ball mill components

Analysis of Ball Mill Components

 

1. Liner bolts: Ball mill bolts can be divided into: compartment liner bolts, discharge grate bolts, stepped liner bolts, cylinder bolts, fixed cone liner bolts, inlet and outlet hopper lining bolts, Cabin bracket bolts, manhole bolts, grating bolts, end cover liner bolts

 

2. Mengsteel lining plate: The high manganese steel lining plate of the ball mill is used to protect the barrel of the ball mill, so that the barrel of the ball mill is free from the direct impact and friction of the grinding body and the material, and can also be adjusted by using different forms of high manganese steel lining plates. The movement state of the grinding body can enhance the grinding effect of the grinding body on the material, which helps to improve the grinding efficiency of the mill, increase the output and reduce the metal consumption.

3. Rubber lining: The ball mill is the key equipment for regrinding after the material is crushed. The process is that the material is mixed with a certain number of steel balls for mixing and grinding. Ring, filler strip, simplified rubber lining plate and lifting strip, manhole door lining plate and supporting fasteners, made of high wear-resistant rubber, with impact resistance, corrosion resistance, high wear resistance, low noise, easy to replace Etc.

 

4. Large ring gear of ball mill: The large ring gear is one of the important parts of rotary kiln, ball mill, dryer and other machinery. The ring gear needs to drive the entire cylinder to run for a long time. Provides high life and high operating rate ring gear steel castings.

 

5. Ball mill hollow shaft: The ball mill hollow shaft is an important part of the ball mill, and its main function is to carry the rotation of the ball mill barrel. The process and processing requirements are very strict to ensure the normal operation of the ball mill.

 

6. Ball mill steel balls: Grinding materials to make the materials finer to meet the use standard, mainly in mines, power plants, cement plants, steel plants, silica sand plants, aerated brick plants, wear-resistant refractory materials plants, coal chemical plants and other fields.

 

7. Ball mill short step liner: The ball mill liner is used to protect the cylinder body from the direct impact and friction of the grinding body and the material. Enhance the crushing effect of the grinding body on the material, which helps to improve the grinding efficiency of the mill, increase the output and reduce the metal consumption.

 

8. Rotary pinion: Due to the large force on the pinion, it is not allowed to use high carbon steel for casting. Sometimes, in order to improve wear resistance, it is necessary to add some rare metals such as chromium, nickel, manganese and so on to produce alloy steel. Guarantees the wear resistance of the pinion.

 

9. Ball mill inlet and outlet end caps: The ball mill end cap is one of the key accessories of the ball mill. The end caps are located at both ends of the ball mill cylinder and are supported on bearings. They are mainly used to support materials, cylinders and media. The end of the hollow shaft of the ball mill The fillet at the root of the disk is the stress concentration point.

10. Bearing seat: The bearing seat is an important component in the ball mill equipment. It mainly carries the entire weight and impact force of the cylinder. The quality of the bearing seat directly affects the production efficiency of the ball mill and the operation safety of the equipment. A good bearing seat has the advantages of high hardness, high wear resistance, strong bearing capacity, continuous work for a long time, good stability and long service life.